DairyMaster · Fast-exit milking parlour
Fast Exit
A DairyMaster system that releases a group of cows rapidly after milking. Stallwork, exit-zone width and cow routes must be engineered together.
Quick decision
Is this solution right for your farm?
Consider it when
Projects where group changeover and exit flow are the main throughput constraints
We clarify before quoting
Herd size, operating zone and housing method, daily load, dimensions and routes, water, power, cleaning and service.
Another solution may be better when
Animal group, layout, capacity, operating method or site utilities differ.
Best suited for
Projects where group changeover and exit flow are the main throughput constraints
Capabilities and controlled parameters
- Front lifting stallwork enables rapid release of the row
- Sufficient space in front of the stalls is required for simultaneous exit
- Entrance, positioning and exit are calculated together with the collecting yard
- Identification, milk recording and milking management systems are available
- Milk, vacuum, washing and cooling systems are configured for the project
- Suitable for new buildings and selected retrofit scenarios following a site survey
Fast Exit: rapid release depends on the right layout
The front restraint releases the entire row at once. Time is saved only when there is enough space in front of the stalls and the following route does not create a bottleneck.
Strengths
- simultaneous front exit for the group
- less lost time between cycles
- good visibility and operator access
- compatible with DairyMaster automation
Check before selection
- requires a wide clear area in front of the stalls
- cannot be assessed without the building plan
- gates and the downstream route must accept the full flow
Official system photography
DairyMaster
Go deeper
Guidance on farm layout, operation and equipment selection.
LabLog
Implementation considerations
The final parlour configuration depends on milking herd size, milking frequency, group size, shift duration, building layout, collecting yard, operators, water, power and milk cooling. LabLog starts with an engineering brief and never defines throughput from stall count alone.
How LabLog supports the project
- 01Capture herd, group and milking-routine data
- 02Review the building plan, collecting yard and cow routes
- 03Calculate parlour type, stall count and operating cycle
- 04Coordinate milk, vacuum, washing and cooling systems
- 05Configure automation, installation, commissioning, training and service parts