Scope
- milk lines and receivers
- centrifugal pumps and level control
- filtration and diversion lines
- air purge and cooling interface
DairyMaster · Milk line
Milk Line System
Milk lines, receivers, pumps, filtration and diversion engineered for parlour type and peak flow.
Quick decision
Is this solution right for your farm?
Consider it when
Any new or retrofit DairyMaster milking parlour
We clarify before quoting
Herd size, operating zone and housing method, daily load, dimensions and routes, water, power, cleaning and service.
Another solution may be better when
Animal group, layout, capacity, operating method or site utilities differ.
Best suited for
Any new or retrofit DairyMaster milking parlour
Capabilities and controlled parameters
- Diameter and routing are calculated from flow and layout
- Receivers and pumps are matched to the milking routine
- Filtration and diversion of non-standard milk are included
- Materials and welds must meet sanitation requirements
- Washing is calculated together with line hydraulics
- Cooling and the milk room are designed as an extension of the system
Milk Line System: milk must reach cooling without bottlenecks
Diameters, slopes, receivers, pumps, filters and diversion are calculated for actual peak flow and the sanitation cycle.
Calculation
- simultaneously operating clusters
- peak flow and route length
- slopes and elevation changes
- milk, wash and rinse modes
Quality
- gentle milk transfer
- flow visibility and control
- event-based milk separation
- rapid transfer to cooling
Service
- seal and connection inspection
- filter and pump checks
- level-sensor verification
- wash validation after changes
Line size cannot be selected from stall count alone. Poorly sized hydraulics affect both milk transfer and cleaning quality.
Components and integration
LabLog
Implementation considerations
The final parlour configuration depends on milking herd size, milking frequency, group size, shift duration, building layout, collecting yard, operators, water, power and milk cooling. LabLog starts with an engineering brief and never defines throughput from stall count alone.
How LabLog supports the project
- 01Capture herd, group and milking-routine data
- 02Review the building plan, collecting yard and cow routes
- 03Calculate parlour type, stall count and operating cycle
- 04Coordinate milk, vacuum, washing and cooling systems
- 05Configure automation, installation, commissioning, training and service parts