Bioeasy / AnyEasy · Rapid antibiotic tests

Bioeasy 4in1 BSCT

Rapid test for simultaneous screening of four groups in milk: beta-lactams, streptomycin, chloramphenicol and tetracyclines. Time, temperature, detection limits and line interpretation are governed by the current lot instructions. The 4in1 BSCT format uses controlled incubation and can be read visually or with a compatible Reader as specified in the instructions.

Quick decision

Is this test right for your control programme?

Consider it when

Dairy farms, milk collection points, dairy plants — incoming milk quality control

We clarify before quoting

Matrix and sampling point, target, decision threshold, test volume, compatible reader, control points, frequency and approved procedure.

Another test may be better when

The matrix, analytical target, required limit, time to result, readout format or approved procedure differs.

Best suited for

Dairy farms, milk collection points, dairy plants — incoming milk quality control

Capabilities and controlled parameters

Method: lateral-flow immunochromatographic screening
4 groups: beta-lactams, streptomycin, chloramphenicol, tetracyclines
Fast result according to the manufacturer’s instructions
Detection limits are checked against applicable MRLs and site requirements
ILVO status is verified by exact test name in the current validated-test list
Controlled incubation follows the current instructions for time and temperature
Visual or instrument reading depends on the test version

Bioeasy / AnyEasy

Go deeper

A selection of materials to understand the method, compare instruments and choose the right lab configuration.

Milk safetyBioeasy 4in1 or 16in1: choosing a test, incubator and ReaderRead article BioeasyAntibiotics in milk after cow treatment: when milk can be used safelyRead article BioeasyBioeasy and ILVO validation: why it matters for antibiotic testsRead article Rapid testsAntibiotic tests in milk: where they are needed and how to avoid mistakesRead article

LabLog

Implementation considerations

Test implementation starts with the matrix, sampling point, analytical target and decision rule. Before supply, LabLog checks reader and consumable compatibility, control requirements, frequency, training, storage and result documentation.

How LabLog supports the project

01Define the matrix, sampling point and target
02Check the decision threshold and applicable method
03Agree the reader, tests, controls and stock level
04Prepare storage, training and a working instruction
05Verify a trial cycle before routine use